The saltwater chlorinator system is used to clean the saltwater swimming pool to remove and reduce dirt, germs, bacteria, and algae. Saltwater chlorinator helps the salt from the water to dissolve and convert it into chlorine.
According to Robinson from poolity, Every swimming must have a sanitizing system to clean the water weekly. Water can easily spread and produce bacteria, which can be very harmful to your health.
Here we are going to talk about the way to use a saltwater chlorinator.
Before going to the chlorination process, you need to check the salt concentration level of your swimming pool. Make sure that the salt concentration of the swimming pool is not more than 3,000ppm.
These are the steps you need to take to use a salt water pool chlorinator.
Step one:
Turn of the power of the pool pump from the circuit breaker. You need to refill the pool with the help of an automatic pool chlorinator.
Step two:
Turn off the pool chlorinator control to allow water and fumes to drain from the feeder.
Step three:
Turn the feeder cap clockwise to remove it. Make sure that you are not standing on it while removing the cap.
Step four:
To Recharge the feeder, add some chlorine tablets or chlorine sticks.
Step five:
Use silicone lubricant to replace the cap. Use your hand to tighten it up. Do not use any lever.
Step six:
Turn on the power of the pump.
Step seven:
According to the required level of chlorine, you might need to reset your valve.
You need to follow these easy steps to use the salt water pool chlorine generator. The saltwater pool chlorine generators can be found easily in stores and can work for up to many years if you are taking good care of the machine.
Refill the automatic feeder when you need it and always try to use the same product which is recommended. Even if you change the machines, you should still keep up with the same products that you are using from the beginning.
Some tips you need to follow when you are using the saltwater chlorinator.
- Clean the pool before starting the chlorination process: Whether you haven’t used the pool for a while or not, you need to clean your pool before starting the chlorination process to minimize the inconveniences. Clean the pool water like normally you do. Clean the debris, cans, sticks, and leaves from the pool to get a successful chlorination process.
- Chlorination during low heat and low lights: We receive UV rays from the sun, and that can break the chlorine, which will hamper the chlorination process. Always work after the sun has set so that it will get enough time to process. The night is the best time for chlorination.
- Use appropriate chemicals: Whenever you are up to the chlorination process, always use the chemicals which are recommended by the experts. Do not go for any experiments. It might lessen your work process, as well as cause severe damages to your pool.
- Turn off the power when you are finished: Always turn off the power of your chlorine generator when you have finished your work. Do not overdo the chlorine process.
- Avoid using the pool during and after chlorination: When you are done with the chlorination process, try to avoid using the pool afterward. Give it time to process the whole system for at least one day. Avoid using the pool during the chlorination process. The chlorine can damage your skin cells and causes serious skin issues.
The saltwater chlorinator system is the most popular way of maintaining a saltwater pool. It is easy to use yet quite expensive. However, it takes less time than any other cleaning process. Furthermore, it is a self-sustaining process, which means that it controls the salt level of your water. A chlorine generator can be used as a long term process to avoid hassles.
